Effimac Product Range HR SLITTING LINE SLHR 1000-2000 | CR SLITTING LINE SLCR 500-1600 | CTL - CUT TO LENGTH | TUBE MILL ENTRY LINES | TUBE MILL | FLYING CUT OFF
bar Home div About Us div Products div Feedback div Contact div Site Map
banner
PRODUCT RANGE
HR SLITTING LINE SLHR 1000-2000
spacer
CR SLITTING LINE SLCR 500-1600
spacer
CTL - CUT TO LENGTH (HR SHEETS)
spacer
CTL - CUT TO LENGTH (CR SHEETS)
spacer
CTL - CUT TO LENGTH (TUBE)
spacer
spacer
TUBE MILL
spacer
 
Home >> Products > TUBE MILL ENTRY LINES
spacer
PINCH ROLL LEVELLERS

Model Number

Width (mm)

Thinckness (mm)

Speed (m/min)

Structure

EPRL-32

40-120

0.6-1.6

15

2+5

EPRL-50

60-200

0.8-3.0

12

2+5

EPRL-76

100-260

0.8-4.5

12

2+5

EPRL-89

100-300

1.0-5.0

8

2+5

EPRL-114

120-400

1.2-6.0

8

2+5

EPRL-165

160-520

2.0-6.0

6

2+5

EPRL-220

240-700

3.0-8.0

5

2+5

EPRL-325

320-900

4.0-10.0

5

2+5

EPRL-508

600-1300

4.0-12.5

3

2+5

The combined pinch roll-levelling machine serves to pull the strip off the decoiler, to level it and to feed it into the end-squaring shear, and further into the strip welding unit.

The machine consists of a welded frame with 2 side members. holding the bearing chucks. and bolted to each other via spacers and cross pieces. The chucks for the lower pinch and levelling rolls are rigidly mounted in the side members. The top pinch roll is raised and lowered by hydraulic cylinder. The upper levelling rolls are parallel adjustable by screw down devices. Pairs of horizontal and vertical guide rollers, adjustable to suit the strip width, are mounted at the entry side of the machine. The upper pinch roll is powered by A.C. geared motor via universal point propeller shaft.

Pinch and levelling rolls as well as vertical guide rollers are made of alloyed steel, surface hardened and ground. and are running in roller bearings.