Effimac Product Range HR SLITTING LINE SLHR 1000-2000 | CR SLITTING LINE SLCR 500-1600 | CTL - CUT TO LENGTH | TUBE MILL ENTRY LINES | TUBE MILL | FLYING CUT OFF
bar Home div About Us div Products div Feedback div Contact div Site Map
banner
PRODUCT RANGE
HR SLITTING LINE SLHR 1000-2000
spacer
CR SLITTING LINE SLCR 500-1600
spacer
CTL - CUT TO LENGTH (HR SHEETS)
spacer
CTL - CUT TO LENGTH (CR SHEETS)
spacer
CTL - CUT TO LENGTH (TUBE)
spacer
spacer
TUBE MILL
spacer
 
Home >> Products > TUBE MILL ENTRY LINES
spacer
SHEAR & WELDER

Model Number

Width (mm)

Thinckness (mm)

Shearing Type

Welding Angle

Welding Type

Gas Type

EPSW200

30-200

0.5-3.0

Pneumatic

0 deg

TIG

Argon

EHSW250

50-250

1.0-4.5

Hydraulic

0 deg

MIG

CO2

EHSW400

100-400

1.2-5.0

Hydraulic

0 deg

MIG

CO2

EHSW700

150-700

2.0-8.0

Hydraulic

3 deg

MIG

CO2

EHSW1000

250-1000

3.0-10.0

Hydraulic

3 deg

MIG

CO2

EHSW1600

450-1600

4.0-15.0

Hydraulic

3 deg

MIG

CO2

The strip welding unit with incorporated end-squaring shear serves to cut the strip ends perpendicular and to join the leading strip end of a coil with the trailing strip end of the preceeding coil.

This unit consists of an end-squaring shear and a mechanized welder with strip clamping devices mounted on a common base.

The pinch roll of the strip accumulator pulls the strip through until the trailing strip end is lying in proper position in the end-squaring shear, where it will be chopped off. The pinch roll pulls the strip further through until the strip end is lying in proper position for welding. The clamping device for the trailing strip end will be actuated, holding the strip end. In the meantime the leading strip end of the following coil has been fed by the combined pinch roll-levelling machine into the end-squaring shear, where it will be chopped off. The strip end will be pushed further until it touches the already clamped strip end. The required welding gap will be adjusted according to pre-set value. The clamping device for the leading strip end will be actuated. The welding will be performed by a motor powered welding torch. The feeding speed is step-less adjustable. The welding arc will be shielded by Argon/Carbon dioxide gas. The welding source is placed in the base of the unit.